Pdoxusrsnet windows 79/21/2023 ![]() We are able to connect with testuser but not able see the directory/List Issue: Client cannot connect to ftp from command line and Powershell Most other support passive mode.įor example WinSCP defaults to passive mode and there's a guide available for converting Windows FTP script to WinSCP script. Use any other Windows FTP command-line client instead. ![]() Unfortunately Windows FTP command-line client (the ftp.exe) does not support passive mode at all. If possible, you should use a passive mode as it typically requires no additional setup on a client-side. See my article Network Configuration for Active Mode. Or your client is not aware of its external IP address and provides an internal address instead to the server (in PORT command), which the server is obviously not able to use. It's likely because of your local firewall or NAT that the server was not able to connect back to your client to establish data transfer connection for the directory listing ( ls or dir commands). Setting up the FTP in the active mode can be cumbersome nowadays due to firewalls and NATs. ![]() Windows FTP command-line client ftp.exe supports an active FTP mode only. ![]()
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |